Генератор yg6600de инструкция


Zach’s house has a lot of natural gas appliances, it allows us to run in 120VAC only mode, and this can have some real advantages. BUT.. If your Generator is 120/240VAC, how do you do that? and why? We’ll cover that here. Широко представлена мототехника российских производителей, а также китайские бренды: Parsun, Sail, Geely, Meitian. The element should be wet but not dripping. Keep it simple Zach Says.. let’s keep this page simple!


The goal of the article is to help make people more self-sufficient, the cost of taking a generator to a shop to have simple repairs made can be expensive, and if it’s a 200 mile trip to town, it can be expensive just to get it to repair and back. Read comments, and see if this makes the selector switch modification more clear? 120-240VAC -or- 120VAC only Selector Switch 2 Now, there’s a bunch of assumptions I make with this example, you’ll know to provide your grounds, you’ll understand that ground and neutral are not the same thing. Here’s a method to accomplish a switch between 120/240 and 120 only, remember, the switch should only be thrown when the generator is off. Page 24: Operation, Starting The Engine AE00955 OPERATION NOTE: The generator has been shipped without engine oil. Адрес: Чермянская улица , дом 31 Продавец: Диана Доставка: курьерской службой DHL.

Remove the oil drain plug so that the oil can be completely drained. Page 1 Generator OWNER’S MANUAL EF4000DE EF5200DE EF6600DE YG4000D YG5200D YG6600D YG6600DE LIT-19626-01-15 7WV-28199-11… Page 3 AE00002 INTRODUCTION Congratulations on your purchase of your new Yamaha. Fact is, some generators don’t quite carry their advertised capacity, so you need know what it will carry, and monitoring the voltage is one way we can do that on the cheap. You might understand the drawing better in the following drawing, when (|) contacts are closed the (X) is open, and when the switch is thrown to close the (X) contact, the (I) contacts are open. Use only distilled water if refilling is necessary. This is normally a more ideal setup if you are going to power a transfer switch and have the luxury of powering 120 volt loads only (no need to power a 240VAC load like a well pump.

Похожие записи: